CaÑO Shirt DWG Detail for AutoCAD
This detail is very well as a connection with pipe shirt for Natural Gas
Drawing labels, details, and other text information extracted from the CAD file (Translated from Spanish):
Cmp of points according to, Mg anode of segun, Cathode, Smooth, of concrete, Of land, Threaded with, Arrestallama, Round head, protection, Dn., Premolded, shirt, Premolded, Caneria’s end, Minimum, Premolded, Caneria’s end, sealing, Location, in construction, separator, sealing, Min., Of roads, shirt, F.c., Of the area, of conduction, sealing, Location, in construction, Min., shirt, separator, Minimum, sealing, Min., Under way, of conduction, Under route, path, Of the area, Dn. for, Pampas, magnetic, Plan, from the south, kind, Of routes, Polyethylene pipe, Federal pcia. Of bs. ace., Of projects, Garcia, Lorenzo, technique, To the plane, Nominal pipe, In special cases indicated by roadway by the companies, the length of the jacket is indicated in the particular conditions by note. The anticorrosive protection of the inner part of the previous surface treatment will be painted with polyurethane paint thickness microns according to the cathodic protection the part not buried of the vents before surface treatment will be painted with epoxy base paint microns polyurethane finish thickness microns Collar using the seals of the shirt will be made of pre-molded synthetic material of recognized brand. These materials will be pre-approved prior to installation. The dimensions of the collar will allow a good centering of the inside of the jacket at crosses when the distance between wire fences is the jacket will extend from the wire to the one on both sides. When the jacket is extended on each side of the main track shaft in secondary tracks. The crosses will become open sky by being subject to the system what the permissive entity sets in each particular case. Attack wells shall be constructed outside the area of influence of the ground slope by considering a friction angle from the edges of the track rails. Unless otherwise indicated by the permit holder. The material of the shirt will be of indicated quality to the contrary astm as a minimum the geographic location of the venteos will be indicated by the inspection of work. Once the crossover has been built, a test of the air must be made for one of them, the other being capped until pressure is reached, during which the venting opposite to the injection through which the air should escape must be uncovered. The dimensions are expressed in millimeters. At each intersection, placards should be placed according to the type of plane. Mm. It met
Raw text data extracted from CAD file:
| Language | Spanish |
| Drawing Type | Detail |
| Category | Water Sewage & Electricity Infrastructure |
| Additional Screenshots | |
| File Type | dwg |
| Materials | Concrete, Other |
| Measurement Units | |
| Footprint Area | |
| Building Features | Car Parking Lot |
| Tags | autocad, ca, connection, DETAIL, digester, DWG, fuel, gas, griffin, kläranlage, natural, pipe, pipeline, tank, treatment plant |